Output mode : NC (normally closed)
Body size : 54 x 66 mm
Stroke : 4 mm
Pretravel : 0
Repeat positioning accuracy : 0.001 mm (operation speed: 50-200mm/min)
Trigger life : 3000000 times
Contact surface : Dia20 mm
Contact force : 2.5N (installation state: vertical)
Contact material : Stainless steel SUS304
Cable : 2 mts (4 core cable Dia5mm) tensile strength 20N / minimum bending radius R7
Tension protection sleeve : 0.6 m (minimum bending radius R25)
Outpoint rating : DC24V 20mA (MAX) recommended value 10mA (resistive load)
Working temperature : 0~+60°C (Ice-free)
Protection class : IP67 (dustproof & waterproof)
Application system : Siemens, Mitsubishi, Syntec, LNC, Fagor, EdingCNC, MACH3, Weihong, etc.
Air blowing : NON
LED indicate : NON
One piece per pack, Made In China
Installation Notes:
1. The pillar and the tool setting device must be perpendicular to the contact surface and perpendicular to the contact surface. Please install them on a workbench with small iron filings as much as possible.
2. Make sure to use the voltage within the rated power supply range, please control DC10-30V, the current is less than 20mA, and the ambient temperature range is 0~+60°C (Ice-free) .
3. Please control the tool diameter to be less than 20mm, and the cutting speed to be less than 50-200mm/min. The center of the tool should fall on the center of the tool face.
