Artikel-Nr.: HSK63FFK
Marke: NAMICAM
Artikel-Nr.: HSK63FFK
Marke: NAMICAM
Artikel-Nr.: ISO30FK
Marke: NAMICAM
Artikel-Nr.: KB045080158005
Marke: NAMICAM
Artikel-Nr.: ER32-12
Marke: NAMICAM
Artikel-Nr.: KB04250650063
Marke: NAMICAM
Artikel-Nr.: HSK63F-ER32-70L
Marke: NAMICAM
Artikel-Nr.: KB042855015165
Marke: NAMICAM
Artikel-Nr.: ISO30-ER32-50L
Marke: NAMICAM
Artikel-Nr.: OZ25B_10H
Marke: NAMICAM
Artikel-Nr.: DIN30FKB
Marke: NAMICAM
Artikel-Nr.: SK40FKB
Marke: NAMICAM
Artikel-Nr.: MSP01
Marke: NAMICAM
Artikel-Nr.: LED3W24V400mm
Marke: NAMICAM
Artikel-Nr.: HSK63FKALUE
Marke: NAMICAM
Artikel-Nr.: DCB2808063
Marke: NAMICAM
AC-Servotreiber EL7-EC750FT EtherCAT
Hauptstrom Steuerstrom: 220 V 1 PH
Nennausgangsleistung: 750 W
Nennausgangsstrom: 7 A
Maximaler Ausgangsstrom: 18,7 A
*Ein Jahr Garantie*
Marke: LeadShine, Made In China
EL7-EC series AC servo drives are using the latest Digital Signal Processing (DSP) chip and Intelligent Power Module (IPM) with compact components integration and great reliability. Using the best PID calculation for Pulse Width Modulation (PWM) control, EL7-EC series products are the one to beat in this product category. In comparison to conventional pulse controlled servo drives, EL7-EC provides advantages as listed below.
Lengthen communication range and lower electromagnetic interference
Due to the reliance of pulse command, pulse controlled servo drives could be easily disrupted by electromagnetic interferences. EtherCAT communication protocol provides fault detections limitations and error handling that makes communication more reliable over long distances.
Greater motion control
Trajectory generation can be done within the driver under non-cyclic synchronous mode. Controller only needs to deliver target position, velocity and acceleration commands to the driver. Drivers can then achieve greater control by applying feedforward to the commands.
Simplify complex wiring work
Using EtherCAT communication protocols, the connections between master device and slave stations can be realized using only LAN cables.
Reduce cost by lowering the requirement for more ports
Multiple axes control can be realized without requirement for more ports or pulse module on the master device/controller. Only a network port is needed to chain the axis controller (drivers) together in series.
Artikel-Nr.: CABLE-TX1M5-BUS V2.0
Marke: Leadshine
Artikel-Nr.: ASD-B2-0221-B
Marke: Delta Electronics