Specification:
Output mode: NC (normally closed)
Stroke: 5mm
Pretravel: 0
Repeat positioning accuracy: 0.001mm (operation speed: 50-200mm/min)
Trigger life: 3000000 times
Contact surface: Dia22mm
Contact force: 1.5N (installation state: vertical)
Contact material: Cemented carbide
Surface processing: grinding 4S
Cable: 3mts (4 core cable Dia5mm) tensile strength 30N / Minimum bending radius R7
Tension protection sleeve: 1m (minimum bending radius R25)
Outpoint rating: DC24V 100mA (MAX) Recommended value 10mA (resistive load)
Working temperature: 0~+60℃ (Ice-free)
Protection class: IP67 (Dustproof & waterproof)
Complete protection against ingress of dust and airborne particles
Protection against water and liquids, up to and including immersion in up to one meter of water
Application system: Siemens, Mitsubishi, Syntec, LNC, Fagor, EdingCNC, MACH3, Weihong, etc.
Pneumatic Connector : Required Air Pipe OD6mm OD4mm
LED Indicate : NON
One piece per pack, Made In China
Installation Notes:
1. The pillar and the tool setting device must be perpendicular to the contact surface and perpendicular to the contact surface. Please install them on a workbench with small iron filings as much as possible.
2. Make sure to use the voltage within the rated power supply range, please control DC10-30V, the current is less than 20mA, and the ambient temperature range is 0~+60°C (Ice-free).
3. Please control the tool diameter to be less than 20mm, and the cutting speed to be less than 50-200mm/min. The center of the tool should fall on the center of the tool face.
